Air Welding Gas Torch Cordless Solder Iron ,Soldering Gun Soldering Blow Iron Pen, Burner Iron Hot Gun Tools Butane

<p>Stainless steel hot air head, better and faster heat conduction</p><p>It is very small and light, easy to carry. No soldering station required, just and play.</p><p>Insulated silicone handle, compact and lightweight design, fast heat dissipation, allowing you to use the soldering iron for a long time.</p><p>Widely used in various fields</p><p>Soldering iron tools are a good choice for soldering circuit boards, home DIY enthusiasts, electrical repairs, jewelry soldering. It is easy to use whether it is an electronics enthusiast or a beginner studying electronic engineering.</p>

• A lighter is needed to support ignition when firing, and the soldering iron itself cannot fire
• ignite:
• 1. Turn counterclockwise to turn on the gas source switch, at this time you can hear the sound of gas flowing and smell a little gas.
• 2. At this time, you can use a lighter to aim at the opening of the soldering iron tip to fire, and then observe carefully, the inside of the opening of the soldering iron tip will turn red. Ready to use,
• Soldering iron valve adjusts the size of the valve to control the temperature of the soldering iron tip. When adjusting the temperature, it can also be judged by observing the brightness of the opening of the soldering iron tip
• The temperature is high and low. There is a certain delay when the valve is closed, the flame will not go out immediately,
• 3. Be careful not to adjust too much, otherwise it will be very dangerous.
• 4. There is a small hole at the bottom of the soldering iron for refilling, which is the same as our lighter refilling.
• Fill gas:
• 1. The switch is in the OFF position, using a high-quality gas tank
• 2. Introduce the gas tank into the air hole and press down to inflate
• 3. After completion, wait a few minutes and use it after the gas is stable
• 4. If the gas is filled in, there is a hissing sound at the tail, it can be eliminated by pressing the pen tip slightly into the air port
• Special attention: the heated soldering iron should not be placed directly on the table or plastic products to avoid scalding the object. Be careful not to touch it with your hands to avoid danger.
• If there are children nearby, you should pay more attention. After use, store it after cooling down.
• Can be used as a spray gun: unscrew the soldering iron tip, open the air valve, and ignite with a lighter, then it can be used as a spray gun. It is very useful for outdoor ignition and welding of plastic products.